Hey guys,
Changed my cut blade for the first time, got genuine roland blades from my local rep/service agent.
Im having issues with smaller stuff having tiny 1-2mm sections on point edge cuts where its not cutting?
Iv checked the offset settings ect and looks all fine, blade tip is only about a card width out the holder.
Any suggestions? In having to manually run a blade over some bits, doesn’t happen all the time but its consistently an issue.
Changed my cut blade for the first time, got genuine roland blades from my local rep/service agent.
Im having issues with smaller stuff having tiny 1-2mm sections on point edge cuts where its not cutting?
Iv checked the offset settings ect and looks all fine, blade tip is only about a card width out the holder.
Any suggestions? In having to manually run a blade over some bits, doesn’t happen all the time but its consistently an issue.