• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

SP300 not printing after damper change

P

player

New Member
Did you draw the ink through the lines and into the damper?

Were you careful to pull off the old damper straight up? The plastic tube the the dampers fit on to are easy to crack, causing lack of vacuum in the system.
 
H

Hfuzz132

New Member
Had it printing on a test print, then it quit printing. Filled the damper with a syringe and got it going then it quit.
I did not replace the o-ring on the line (didn't have one). Any ideas?
Replaced dampers before with no problems,
 
S

sidcon

New Member
Hi, Did you find the cause or fix? Does anyone know if the bladder is replaceable on the head and if so where to get them. Im also have issues.
Thanks
 
You must log in or register to reply here.
Top