• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Summa D75 place tool under Barcode when there is no Barcode.

G

Gary1

New Member
I printed some lettering and placed the print to be cut in the D75. When I hit cut (SignLab 10), the cutter is telling me to place the tool under the Barcode. I never printed a Barcode. I checked SignLab VPM and no Barcode is selected. I've had this cutter a couple yrs now and this is the first time it's done this. I rebooted the cutter and it's still asking this same question. Any ideas where to start looking?
 
G

Gary1

New Member
Tech called back and Alignment mode was set to Barcode when it should have been set to OPOSX in my case.
Problem solved.
 
You must log in or register to reply here.
Top