matic serbelj
New Member
hey! sorry to hijack this topic but have some problems with my S2 , but only in sheet mode.
I think its a usb problem. I often do cut sheets and this is annoying. I run the sheet mode and after a few sheets the cutter starts acting up. It doesnt find the marker, then i have to show it to him ...and after a few ... it just "crashes" and i have to reset the cut and start all over. I tryed with new usb cable and still the same, then ...i installed everything on to another laptop, basicly the same hardware and exactly the same software ..and it works. Any idea what i could do?
video of what has been happening.
thank you
I think its a usb problem. I often do cut sheets and this is annoying. I run the sheet mode and after a few sheets the cutter starts acting up. It doesnt find the marker, then i have to show it to him ...and after a few ... it just "crashes" and i have to reset the cut and start all over. I tryed with new usb cable and still the same, then ...i installed everything on to another laptop, basicly the same hardware and exactly the same software ..and it works. Any idea what i could do?
video of what has been happening.
thank you