summa s75t mainboard upgrade

[decaldude1137]

anyone have a factory image as i replaced the mainboard in my summa s75t with the upgrade kit and my touch screen on the s75t cracked and wont let me do anything so i can't boot into service mode to make a backup of my machine and now the new board is giving me all kinds of fits anyone have a copy i could get would be greatly appreciated tried on summa.com put in serial number says accepted but does not give me any files thx.

 

[cornholio]

You don't need to go into service mode to backup the parameters. Just start it up and do a backup from cutter control.
If not possible, write to summa. They should have the file somewhere. (These cutter can be over 20 years old...)

 

[decaldude1137]

thank you as i know its just some settings because the old board only gives y axis overflow now the new board gives head can't find home and up down something error and the blade just spins at a high rate

 

[balstestrat]

You can download the factory backup of your cutter from summas website.

 

[decaldude1137]

i tried it shows no files to download under the serial number

 

[jerry369]

anyone have a factory image as i replaced the mainboard in my summa s75t with the upgrade kit and my touch screen on the s75t cracked and wont let me do anything so i can't boot into service mode to make a backup of my machine and now the new board is giving me all kinds of fits anyone have a copy i could get would be greatly appreciated tried on summa.com put in serial number says accepted but does not give me any files thx.

If you installed the S Class 1 conversion kit composed by S2 right cover, touch screen and flat cable you must install the S Class 2 firmware. Run SCC in service mode and set Service parameter S1_class to 1 and machine type to S2T75

 

[decaldude1137]

ok will try that

 

[decaldude1137]

did that and still same error here are the two im gettiing
up/down encoder not working
then cutter is unable to find home and the tang knife just sits there and spins
if i put the old board back in don't get these errors thats how i know i must be a setting somewhere

 

[decaldude1137]

can anyone send me a backup file for s275t cutter please

 

[jerry369]

Did you reconnect all wires in the right place in the mainboard? as reported in the instructions to install the conversion kit

 

[decaldude1137]

did not have directions just took pic of old board and connected the wires the same