• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Tap and Die Question

ams

New Member
I am putting in a 1/4-20 tap into 1/2" acrylic that is 3/8" deep. I've tried using a cone shaped tap and it's got too much of a taper on it, so after research apparently I need a bottoming tap.

Amazon carries a set of 3 taps, one of which is bottoming, but I don't think I need the other two since they taper. I found a single one on Grainger, just the flat bottoming one, so I really don't need the taper ones correct? I don't think they work with 1/2"

tapdie1.jpg


tapdie2.jpg
 

Joe House

Sign Equipment Technician
You should be able to find a 1/4-20 bottoming tap at your local Ace or True Value store. It's a pretty common size. Sometimes it's easier to just go put eyes on the thing. Also, you may need to start it with the normal tapered tap just to get some light threads started.
 

bob

It's better to have two hands than one glove.
Why a bottom hole? Why not a through hole, far simpler to tap. A bottoming tap is a b1tch to start, usually you start with a tapered tap and then finish with a bottoming tap.
 

ams

New Member
I can't do a through hole, it's separate letters and a routed graphic and all, like 30 pieces. All local stores only have taper, so I ordered a bottom one on Amazon
 

Nuagedesigns

New Member
Take A tapered tap also known as a gun tap and take to belt sander. Lightly grinding away the tapered tip do not burn use water to cool at intervals. Now you have a bottoming tap that will actually tap threads all the way to the bottom. Always use a tapered tap first and bottoming tap second to assure your threads are straight.
 
Top