UCJV300 Error 90d

[Smoke_Jaguar]

Got a fun one that's been haunting me for a while. It pops up randomly at times, so not too easy to pin down. Guaranteed error if you do a print cleaning cycle with just head 2 selected and will occasionally pop up on a supply ink/overflow error. Error 90d.
Service manual states:
1. Check the number of the mounted heads set in the parameter. (System parameter No.66: "UCJV150"=1, "UCJV300"=2)

Parameter is correct, however head 2 seems to never really get cleaned (also cannot be cleaned alone). Currently stuck on firmware 2.9, so might be a bug in that version (3.2+ is current I think). Not really sure where to go on this one as it seems to be a total oddball. Also, not sure if firmware can be remotely updated by a Mimaki tech or someone with a 'borrowed' updater. Dropped AmCad an email as PDS seemed uninterested, but it seems like an unnecessary issue.

 

[Solventinkjet]

Make sure your Maintenance Parameter number 0 is set to 0. It sounds like the parameters may be conflicting. They both tell the machine what model it is so maybe one is overriding the other.

 

[Smoke_Jaguar]

Maintenance Parameter 0: MECATyp * 0
Saw that in the manual as well, appreciate the feedback.

 

[SGC]

Was a head wash done at any point where the service menu fill up was not done by mistake? I lost my head select cleaning ability after a head wash from doing the wrong fill up cycle after head wash.

 

[Smoke_Jaguar]

Got the printer used, and seems the issue came with the printer.

 

[Solventinkjet]

I'd get the original parameters from Mimaki and start from scratch. It sounds like the parameters are messed up. That error is related to a parameter mismatch of some sort and a lot of the time reverting back to the original ones will fix issues.

 

[Smoke_Jaguar]

Guess I will give it a shot and contact them, seems there is an issue with the firmware updater in RL6 as well. I know parameters are their own thing, so I guess I need to try and see if there is a separate parameter upload/download tool as well.

 

[Smoke_Jaguar]

Well that was a waste of time. Mimaki's corporate response was to say it was too complicated to do and that they didn't allow anyone to have access to the software tools to do a parameter reset. No luck with AmCad in Dallas either, seems they only work on machines they sold. Gotta fight for your right to repair.

 

[Solventinkjet]

Gotta fight for your right to repair.

I agree. Seems to be an uphill battle always.

 

[Smoke_Jaguar]

Seems the issue is popping up again with new firmware and factory restored parameters, joy. Thankfully I have parameters, and the program to set them now. Shh, it's a secret. The printer did work ok before, but now, without proper cleaning on head 2, clear/white go to hell and stay that way.

 

[Smoke_Jaguar]

Quick update, factory parameters with just adjustments made to ink fill status, still get the same error. Slider comms seem good, reset battery/SD card in case those might be holding wonky parameters. Talked to a Mimaki tech I know and he said he's seen it before and will try and to look into what the remedy was. As far as I can tell, it is some sort of bug. Firmware 3.0 and 3.4 as well as the old 2.8 I was running all did it. 3.4 seems to be the latest as well. More updates as they come.