• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

V-Carve Routing through SignLab

A

Artist369

New Member
We use an older version of SignLab on our computer that is connected to the router. Is there a way to set letters up to do a v-carve without using the engraving fonts?
 
tbullo

tbullo

Superunknown
What version do you have? I think when we had 4.95 we had to get the 3D module. I use Profilelab and it's just a selection to pick for routing. Toolbar has, hog, male, female, online vcarve, bevel, drill and some more.
 
You must log in or register to reply here.
Top