Versacamm not cutting corners...

[Tony Rome]

I experienced something I never have before with my 540v.
I was contour cutting after laminating and when I went to weed the design it seemed like none of the corners cut the whole way, almost like it skipped just a small spot to finish the angle.
I thought my pressure was fine, would a new blade really change anything.
I did go back and look at my design in corel, definitley OK there.
Any advice? I will try bumping the pressure up even more.
Thanks.

 

[Andrew O]

If you are creating and processing jobs the same way you always have, and this is cropping up for the first time, I'd recommend a blade and a cutter protection strip. Many problems can be traced to these two items, and the cutter protection strip in particular is an oft-ignored part that is inexpensive and easy to change. Your local dealer should have both, or they are available here:

https://www.rolanddgastore.com/

 

[Robert M]

Blade off set

Look at blade offset in the owners manual, if you are not completing the countou this could something to with it

 

[Charlie J]

I can remember having a simliar issue. I think its a setting in versaworks.

 

[Tony Rome]

It was the blade, thanks everyone!