-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Versacamm SP-300V
- Thread starter Moojo
- Start date
Zoogee World
Domed Promotional Product Supplier
Apart from what was advised above, you could clean the encoder strip and sensor and see if that helps, but as mentioned, typically when you get that error, it's the cable.
jharler
New Member
I had this exact problem. I could fiddle with it and get it to register properly, but eventually it got so bad it took 10+ attempts. Replacing the cable as Frank suggests here was the solution.
I'm not sure if linking to products is allowed, but googling "flat cable card Roland SP-300 23475213" will link you to the cable I purchased. It's currently available for $7.12 from the supplier I used. It was pretty straight forward to replace.
Thank you so much. I ordered this part. Sure hope it works! Appreciate everyone's help very much
I ordered that part number and it arrived but it's twice as wide as the one in the machine. Help. TY
jharler
New Member
I have to apologize. I copied the wrong cable from my order history. When I ordered, I wasn't sure which cable I needed, so I ordered a few different ones. I believe the cable I used was this one:
us.digiprint-supplies.com
It seems to be the right size.
Again, I'm sorry. I should've taken the time to double-check that I was pointing you to the right cable. The website says that other cable is used in the SP-300V, so if you hold onto it, it might come in handy in the future, but that doesn't make up for me pointing you in the wrong direction.
SP-300 Cable Card, 15P1 1900L BB - 23475207
This generic, high quality flat cable card is suitable for Roland SP-300 printers.
us.digiprint-supplies.com
It seems to be the right size.
Again, I'm sorry. I should've taken the time to double-check that I was pointing you to the right cable. The website says that other cable is used in the SP-300V, so if you hold onto it, it might come in handy in the future, but that doesn't make up for me pointing you in the wrong direction.
jharler
New Member
I also ordered this one: https://us.digiprint-supplies.com/en/sp-300-cable-card-21p1-180l-bb-23475214-pcbrosp009o
Thank you so much. I'll order that one!!I have to apologize. I copied the wrong cable from my order history. When I ordered, I wasn't sure which cable I needed, so I ordered a few different ones. I believe the cable I used was this one:
SP-300 Cable Card, 15P1 1900L BB - 23475207
This generic, high quality flat cable card is suitable for Roland SP-300 printers.
It seems to be the right size.
Again, I'm sorry. I should've taken the time to double-check that I was pointing you to the right cable. The website says that other cable is used in the SP-300V, so if you hold onto it, it might come in handy in the future, but that doesn't make up for me pointing you in the wrong direction.
I appreciate your help very much. I think I want to order an encoder strip for the same machine. You don't have that number, do you?
FOUND IT!!!
ChicagoGraphics
New Member
Very easy to find on digiprint