Welcome To Signs101.com: Largest Forum for Signmaking Professionals

Signs101.com: Largest Forum for Signmaking Professionals is the LARGEST online community & discussion forum for professional sign-makers and graphic designers.

 


  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Suggestions Wasatch Contour Cutting after Laminating Info

Discussion in 'General Software' started by JohnBoy1972, Oct 9, 2018.

  1. JohnBoy1972

    JohnBoy1972 Member

    37
    0
    6
    Feb 5, 2018
    Tampa
    Hi this is John. I need some instructions on contour cutting a printed image after it has been laminated. I have the printing down, I have the registration marks down, and I have the laminating down. My problem is I don't know how to proceed once I get the image printed and laminated. I know I need to put the sheet back into the machine but I don't see anywhere on the Wasatch Softrip software to actually cut the contour.
     
  2. Mkk8

    Mkk8 New Member

    3
    3
    3
    Dec 28, 2017
    Finland
    Hi John.

    Quite old thread but have you figured this out ?
     
Loading...

Share This Page

 


Loading...