Write Port Error- Flexi 10.4

[Intense01]

I am having an issue on a large 25'x4' decal I am currently printing. It gets anywhere from 25% to 95% completed and then I get a write port error. I rebooted the computer and the printer. I changed the profile also. Anyone have any ideas on how to fix this? It prints the same logo as a smaller size without an issue. It is when I go to the large size there are issues.

Any help is appreciated. I have wasted a half a roll of Ij180 so far and am not a happy camper.

 

[CS-SignSupply]

Did you resolve the issue you were experiencing? I would like to know more about your setup; printer, computer, connection type, direct connect to printer with crossover or via network switch/router?

Sounds very much like a network drop due to connection method or hardware in use.