Recent content by ArkansasSign

Poll size could definitely be the issue. I have facepalmed many a time printing on 60" material and see the production manager say '59.xx' but once it actually starts printing it will print at the 54" it was originally sized to, usually just resend file to PM after poll sizing in Flexi before it...

We do these every October for breast cancer awareness. Check out my Instagram @strictlystickystuff. There's some in-progress pictures a few months back. We literally just take up a roll and drop it down. It was hot but it was fine, they didn't care about seams because it was temp. The Buick...

Its 4'x8'. Router was working when we moved to our new location. Once we got set up again it didn't work. Was told it was a motherboard which we got but then decided to upgrade to something that fits our needs a little better. Comes with vacuum and mister. Asking $3,000. Also have a dust...

Providing the highest quality signage and wraps to northwest Arkansas.

Thank you for this information. We have been encountering multiple head strike issues with the 15oz Key Blockout. I have not tried turning off vacuum but had a feeling it was being grabby. Do you put it on the take-up reel before you start printing or just make sure it's past the felt pads?

It may just be a matter of rotating the re-outputting and sending the contour job only. But I haven't got to test yet. It'd really be nice to have this option under Job Properties though.

When we print stickers the roll has to be re-rolled to the opposite end for the contour to be orientated properly. Usually the laminator flips it, but in case of unlaminated prints is on the opposite end. I was able to do this with my old Summa and was just hoping.

How do I rotate my entire cut file 180 degrees before I send to the plotter in production manager? Is this possible?