Recent content by Aussie Mick

In the book it says to check if the blade is at it lowest position and does not slide up and down. Question - how far is it supposed to slide up and down the small sliding rails. say 5mm or is it more.

all of the above.yes you can set it in the machine and or have the software send it. we do both. we have aspecific setting for laminated material pressure has been 80 all along. when we set it in the cutter at 80 same thing wont cut.we needed about 190 to do anything. we keep trying the test...

I have tried about four blades. I mean it will cut staight through the laminate and vinyl if you lightly cut manually with your hand. Does not seem to matter what pressure or speed or blade out still wont cut. Cut normal vinyl ok. Wondering if there might be a problem with pressure sensor or...

I had to close my business due to unforseen circumstances. Have moved my fx on but still have about 25 - 30 fx foils in variuos stages of use quite a few new and near full ones. would even be worth rewinding onto edge 1 or two rolls. I reckon abot 500 smackers shipped anywhere in Australia...

If you are an aussie . I have about twenty five to thirty foils for fx some new some half. also 4 cartridges. Went bust due to unforseen circumstances. Lost my gerber not suppose to do this I don't think. Contact me can send anywhere. Thanks Mick

Thanks guys that is a rel help. Kind of what i figured about the 3m Seems thats the case in a lot of different areas. Mick

We are paying big bucks over here for ink. To Land two cartridges of ts ink is over $500.00 Auzzie Dollars. Now they tell me we have to change to a new Eco-HS1 ink. Anyone heard of it or using it. (same price) Have not seen much discussion on bulk ink. Plenty of systems and ink types...

I have a JV3 Just wondering if any one has any information to help me. Has anyone used the Mac Tac Street wrap vinyl that is used on cement and or bitumen. Are there any other products the same. Any issues with indoor and or outdoor floor vinyls. Is floor graphics being used as widely as some...

Bulk Ink We are paying big bucks over here for ink. To Land two cartridges of ts ink is over $500.00 Auzzie Dollars. Now they tell me we have to change to a new Eco-HS1 ink. Anyone heard of it or using it. (same price) Have not seen much discussion on bulk ink. Plenty of systems and ink types...

Floor Graphics I have a JV3 Just wondering if any one has any information to help me. Has anyone used the Mac Tac Street wrap vinyl that is used on cement and or bitumen. Are there any other products the same. Any issues with indoor and or outdoor floor vinyls. Is floor graphics being used as...

ok I am in the wrong section here. How do I make a post. Der

Bulk Ink We are paying big bucks over here for ink. To Land two cartridges of ts ink is over $500.00 Auzzie Dollars. Now they tell me we have to change to a new Eco-HS1 ink. Anyone heard of it or using it. (same price) Have not seen much discussion on bulk ink. Plenty of systems and ink...

Floor Graphics I have a JV3 Just wondering if any one has any information to help me. Has anyone used the Mac Tac Street wrap vinyl that is used on cement and or bitumen. Are there any other products the same. Any issues with indoor and or outdoor floor vinyls. Is floor graphics being used as...