Recent content by Brandon708

Can the Colorado print White ink sandwich mode reverse print on clear?

Based on the measurements. It would seem that they are V grooved ACM signs then screwed to wooden posts. Looks like you can get three of the signs out of a 4x8 sheet with each sign using a 48"x32" panel. I can see that they would make these with V grooves going vertical and then bending them and...

I wanted to go to the show in GA to see the Vanguard VK3220-HS printer as they were launching it there. I wasn't able to make it out there to see it unfortunately. I was hoping to see some videos on Youtube or social media about it. I searched and found nothing. Nobody talking about it or...

Nice saw. If you want to cut ACM and aluminum with perfect clean edges get a stomp shear or pneumatic shear. I have a pneumatic shear and use it constantly. It just doesn’t cut .080 aluminum that well. It does but it struggles. I mostly use the panel saw to rip material.

Nice saw. If you want to cut ACM and aluminum with perfect clean edges get a stomp shear or pneumatic shear. I have a pneumatic shear and use it constantly. It just doesn’t cut .080 aluminum that well. It does but it struggles. I mostly use the panel saw to rip material.

Some towns won't enforce the code unless someone complains about it to them.

Use the cheapest laminate you can find. In my experience they change brokerages before they can get full use out of their signs.

Wow. You must be new to the sign industry to just realize that you can just install a "LED Billboard" somewhere and expect to get away with it. That does fall under Offsite Advertising and isn't allowed in almost all of the towns in my area. You would of probably got it approved if it was for...

Maybe it's the absurd number of ads slowing down the site. :confused:

Hi I need help locating an electrical wiring schematics for a Multicam Celero 5. I need to know how many amps /and how to wire up the electrical and vacuum pump. Any hep would be appreciated. Ps. I need to give it to my electrician to run. Thanks!

HP is recommending Dibond as I am having issues with ACM scratching easily on the R1000.

Im seeing Wensco a local supplier I buy from has it too. I thought they only had Aluapanel. They are at $216 a sheet and 10+ For $205 ea. Why is this material so much more expensive than other ACM brands? I used to buy it a very long time ago when they first got to market. I don't remember it...

Yes. I told them I needed 150 sheets. Got a price of $200+ per sheet. :/

3mm White, Double sided, for direct print.

You need two 220 outlets to run the printer. You will also heat that room up way to much with the heaters on the machine. The 3 series printers give off a ton of heat. I wouldn't do it or advise someone to do it.