I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Can anyone help me identify this font? I have tried several different matching softwares but they haven't been any help. Thanks in advance for any help you can give.
Sorry for how the link is, I'm not real sure how to upload pictures here.
Imgur: The most awesome images on the Internet
Think I should up the preheater a bit? Or the platen? Sorry I haven't messed with the temperatures much always used the temps that the printer defaulted too.
When printing I am noticing some bleed. Especially where black ink meets the white vinyl. Have also noticed it a little when printing some reds. The reds seem to have a orange line only at the top, and the black bleeds into purple around the edges meeting up to the white. Anyone have any...
Thanks I will try this. Yeah when you first turn on the machine the heaters will come on for a certain amount of time, but they only heat to the setting that the printer is on not through production manager. I will check this out though maybe this will do what I want. Thanks for the reply.
Anyone know how to change the heater settings from the printer? I can do it from flexi, I just would like to have the heater already warmed up so I don't have to wait so long for it to warm up when I'm ready to print. Thanks
I did! I was to the point that I had no idea what to try next so I decided to take the printhead and the MS back off and start over. Well after putting them back on it started working. I think the printhead may not have been seated all the way. So it wasn't getting a good seal to the capping...
I just recently went through a world of issues with no ink movement in the lines, so maybe I can shed some light. If you pull off the dampers and sunction from there can you move ink? If yes but you can't pull ink from the waste tubes then it could be that the head and capping station aren't...
So far it only seems to be my black to white gradient that does this. I design in flexi and then send it to production manager. When I switch back to flexi 8 on my old computer the gradient doesn't look like this.
I recently updated to flexi 12 and since then have noticed some major changes from flexi 8. I am having trouble with some gradients. They look very odd. I will add a picture. Thanks for any help.
Pictures attached here sorry for quality
https://imgur.com/gallery/Buspn
Well guys I finally got it! I think atleast. I will try to print something as soon as I can get the printer to read the media. I keep getting undefined media.
Thanks for the reply. When I try to pull from one of the waste tubes with the other clamped, I get a tight suction but no ink movement and I also can't hear any air.
Well after replacing the dampers there is no change. I am looking at the CR board now just trying to rule everything out. I have found a fuse on the board that I can't get continuity to. I am not sure what this fuse does or if it is a fuse. I am posting some pictures if anyone of you have any...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.