Recent content by chrisx28

Switched out the MAINTENANCE ASSEMBLY and I am back up and rolling, perfect nozzle check! Thanks to all of you for your help, I learned a ton in the past week.

Switched out the MAINTENANCE ASSEMBLY and I am back up and rolling, Thanks R at signwarehouse.

Looking for a 2nd one but that price is a bit high in my eyes.

Just got a new maintainance station because my M stopped printing than a few days later so did CYK so i called sign warehouse and he suggested a bad station and i just got it in today. Now before I take the leap of replacment is there a way to tell if a damper is bad? I can pull ink from all...

Im not pulling any ink and I took out the capping stating flushed the lines and so on, I am 99% sure I put them on right but not possitive abnd wondered iif this xould be causeing my problem, I have the 2 short lines stright above each other and the long line that recooonects to the station...

Ok I switched the Damper M to Y and vice versa than did a ink charge and no ink is pulling into the lines at all. I tried 1 Strong Cleaning and 2 charges and for sure none of the lines are pulling ink. I took the station out and poured cleaning fluid in it and it drained through the tubes I...

Error was a data strip on the back right in needed pulled forward a bit, Now to get that M flowing again.

Error was a data strip on the back right in needed pulled forward a bit, Now to get that M flowing again.

Yep when I pulled the head out I bumped that ribbon looking thing that is on the back right, I am thinking that must transfer data from the head, wow I am happy to have that fixed. Thanks for info Chris

I did a damper swap and now i am getting this error upon start up, any ideas?

Artbot did what you said and all cables look fine.

Art if you arent busy I will pay you to give me some phone support!

Well Artbot I just swapped the Y and C dampers and I and getting this weird error code. The printer starts and than head moves to the left a wee bit than the error pops up and says E068Err CR Encoder and the lights just flash. Any ideas what is going on now? I cannot do a print to see if I...

Ya I have been known to kick a few cans myself but no Art this wasn't and still isn't a frustrating process, I am learning here and as long as I am learning I am ok. My machine is not for profit so I'm not losing money, if I was than yes shit would be flying everywhere! I noticed you spend a...

Deal is that I have 3 sets of cartridges and all of them started giving me errors 1/2 way to 1/4 of a way through that they were near empty. I had Sign Warehouse send me new cards and after I did that print M can up as empty although it was near full, I swapped the cards and the cartridges are...