I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
My cut feed adjustment is off and I have tried all that I know to correct it. I have run a cut adjust calibration. The scan direction was perfect at zero but my feed adjustment said I was off by -0.4mm (cut line crossed the bottom mark at -0.4mm). So I went ahead and adjusted the feed...
Thanks for all the great info! I just to eliminate and change due to movement I went ahead and tightened down both heads and ran two consecutive test prints without touching anything and got two different results. I attached a picture of both test prints. I also printed a printer report and...
Thank you for the reply Joe!
Yes the spring is installed.
I have been adjusting the 1.5mm allen screw to set the head alignment. I loosened the three screws on the head by tightening them and backing them off just a touch so the head will move with adjustment. The interesting thing is...
I just replaced the print heads in my sp-540v and am doing the head calibration. When I do the bias calibration I will get different results (shifts) without even making any adjustments. Also when doing the bi- directional calibration I get a head height too high message. Went into machine...
Hey everyone, I took a bit of a hiatus from sign making and am jumping back in. I recently purchased a SP540V and went a head and refurbished it head to toe. I performed a factory reset and performed the ink fill procedure. My problem is it was running the fill procedure for quite some time...
Hi Bigblocktrader,
Thank you for the reaponse. I have not tried that. But I will try that. I did do a head soak and the cleaning solvent went down pretty easily. But i will try flushing out the cap tops.
Still learning my way around the machine. Just got it not too long ago.
Thanks...
Hi everyone, Happy New years eve!
As I head into 2017 I wanted to give my printer a cleaning since the blue and black print heads were deflecting a little. So I went a head and put in a cleaning cartridge and drew the cleaning solution through the blue/black print head with a syringe. I...
Thanks for the help. The machine has new capping stations and wipers. I'm not sure about the pump being clogged. I will have to look into that one.
I was thinking that maybe buying one of the cleaning cartridges and doing a power clean or two might help.
Thought's on that strategey...
Hi Everyone,
While I have been a member since 2011, I haven't bee very active due to personal changes in my life over the years. I am now working on getting back to sign and graphic making. I am here to learn and as I get more experience I looks forward to being a greater contributor to...
Hi Everyone, I have a Roland SP-300V that is giving me banding issues. I went ahead and did a calibration and a few head cleanings with no improvement. After running a test print I am getting some over lap on the black, cyan has some drop out and missalignment, magenta has some drop out and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.