Recent content by iraney

Envision SV480...I've had a job on hold for months because I can not get this material. It's back ordered with no timeline on availability. ???

Bron Killer red tape. You can order it in wide rolls. Works great!

Try Herculite by Bantex, it will roll into the bannerstand without the edge curl

Install it with temps under 78 degrees if it's hot out it will get sticky.

stick with corel there is no dimension tools included with illustrator.

check to see if you have a bad or loose rubber wheel where it clamps the material.

a zippy knife is all that is allowed near our laminator.

It's Science

most if not all gray adhesives is a solvent based adhesive and solvent and water don't mix most clear adhesive like Oracal 751 vinyl is a water base adhesive so wet app all day the glue will absorb some of the water over time will eventually evaporate check the oracal website on the material it...

Oracal 3951 has a solvent based adhesive you should never wet apply that the water will not be absorbed into the adhesive since they don't mix it will fail over time since some of the water will be trapped and just expand due to heat.

I usually use heat and wiggle it off then clean the adhesive off the glass.

A gradient like this? kind of hard to guess unless you upload a sample.

never use 3rd party inks for a roland no matter what they say or how much money it saves you in the long run stick to OEM inks.

Uncheck that box and it will bring up the option to include border or not. EDIT: swapped bounding box to include border they call the artboard border for some reason.

Are you suppressing options on export when you export a PDF?