I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
Got a odd problem, when trying to add the old gal (SP300V) to onyx it crashes while trying to install the drivers, even tried a fresh install on another system and same issue, can add the mimiak and mutoh printers fine.
Anyone encountered this before?
Found an annoyance with versa, when I select to create a new media profile at 1440x1440, I only get the option for angled screen halftones (which prints nasty), is there anyway to make it so I can use dither or any other halftone?
Fresh from a versaworks issue, and now in to a flexi 10.5 profiling issue, once I get to the multi-ink limit page change the percentage to the desired percent based on second print verification and then clicking next button, just does nothing where I’m sure it should go to the next step of...
has anyone managed to get a i1pro 2 working with versa 5.51? when I go to calibration if throws up the error 4087 and if I click mesure it throws up 4085/7 any advice would be most welcome as I was under the impression the i1 was backwards compatible (printer is sp300v)
Thanks
Changed over the head cables and now I get the following problems shown in the photos, one is of the test print that looks horrendous and the other is a photo i've been trying to print since this whole mess started.
Will be bald by the end of the week at this rate.
Just started to print a photo to canvas and I get these strange ruler type marks being printed, see photo below; I can't for the life of me understand why.
Using fiery xf 7.1.1 but nothing has changed in the rip
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.