Recent content by kyprinter

I've cleaned the decoder strip. I've turned off RIP while printing. I've cleaned RIP queue, and holds. I've deleted tmp files. Any my tiling is factory set. Its still doing the skipping at the end of the printing. HELP! I'm so far behind after this week!

I have run 6 different prints of the same design and its "skipping" in the exact same place. Its also "skipping" on other designs as well, right towards the end of the print.

Neither worked. How do you clean the RIP queue? Excuse my ignorance.

I will try that too. It just started doing it this week.

Thanks! I'll try that. I've wasted so much vinyl!

HELP!! Why is my printer doing this????

THANK YOU!!!!!

How do you turn on the heaters on a Mutoh 1324x using the printer menu? Not through the software. TIA!!

Can someone tell me how to prime the cap? I was told by the guy who sold me the MS to drop some distilled water onto the cap with a syringe. Is this the only way to do this? Is this the correct way to do this?

How did you prime the cap?

Not a single drop of ink prints.

Could someone with a Mutoh 1204 post a picture of your printhead gap on the platen? Attached is a picture of mine, but I’m being told it’s not where it needs to be. I can’t get it any lower!!! I’ve got to get printing!! Haven’t printed in over 2 wks and jobs are backing up!!!

I have replaced printhead cables, checked printhead height, checked F2 fuse, still nothing. Could I have gotten a defective maintenance station that isn't working correctly. Not sure if the MS pump is actually trying to pull air in or not. Any other suggestions before I throw this thing out...

I've changed print cables, fuse checks good (even though I bought 2), printhead gap is level, still nothing! I'm at a loss! Could it be a defective maintenance station even though its new? Will post a video of maintenance station working.

Thanks! I will check that!