Recent content by neobruo

Hi there, I don't know if you already solved the problem but I will give a tip. Never left the media lift lever open because if you do it the printer doesn't make the automatic periodic cleans. It starts but it stops right away because with the media lever open the printer think you will...

Bring it on!

Here I am!!!

Disassemble the engines pca 1 and 2 on the main board slots and clean all contacts and cables. Becarefull with the cables positions.

You need to disassemble the curing module and clean it for maximize efficiency. Clean also the ventilators on.

It is not possible because the hdd partitions! (linux format ext4 partitions) I don't have technical contact with FB750 but I do have with FB700. I always suppose that if the part number of the two hard drives are different, they won't work at different FB models!

Hi: You will need to remove the left and right covers, carriage belt, encoder, printheads, trailling cable and ink tubes. then you must to remove the carrige out and replace de printheads cover. Do the reverse procedure. It's a elaborated procedure, but it's peanuts!

Hi: As a technician, to solve that problem you need to dismantle the pinch rollers supports at the back of the printer and clean the lubrification oil deposited. that happens when the felts at carriage and the shaft are extra lubrificated and lead the oil to stay deposited at those pinch...

fb 950 Hi: can you tell me how you solved this problem? appreciate a lot if you can help. I'm exactly with the exactly same problem...

Problem solved. Motor control board replaced and all works good. Thanks to all.:wink:

Sorry friend, but i do not agree. Try to adjust curing temp in profile, and decrease the amount of ink too!

14.10:00 - Open circuit on the Dryer Assembly If that happens again, check the drying thermostat. it can be be malfunction or a overheating occurs

Hp tells me to replace the media motor, motor, and motor crontrol board...I'm from Portugal and the representative supplier showed me a budget of nearly $ 5, 000! I can't support it right now!

I removed the media motor and encoder and installed on another FB950 and gave the same error. I swapped the encoder plug and plugin at the original encoder and the error desapears! figured out it was the media motor encoder. I buy a new encoder, installed and... it keep the same error... The...

The printer was working fine and then... This error appears and the media belt stoped working! I allready replaced the high definition encoder but it doesn't solv the problem. The media belt motor was tested out of the printer and it works fine. I performed a measurement of continuity in the...