Recent content by robsonr

I think that side margin setting is only for the left side. Am I wrong?

Thank you Wayne. I checked the official documentation and you are right. I thought that I was printing full width but I must mistaken.

Hi everybody, I am puzzled. I use 54” inch material. When I send a full width image (54") to be printed, the printer creates a white (un-printed) margin of 30mm on the left hand side. As a result I cannot utilize full width of the material. I tried two different RIP programs with same results...

I wanted to update the thread with the progress in my case. I bought new dampers, but it didn't help. I ran from service menu some tests where I realized that I have nozzles blocked, head voltage was set correctly according to test print. I decided to perform head cleaning using flush fluid. It...

Thank you for all your posts. I figured out that my problem is a speed setting. I had it set to 60 which resulted in behaviour I observed. When I lowered it to 26, ease of weeding improved significantly. I still need to play a little with those settings to find the best setting for specific...

Hi everybody, I have been struggling for some time with a print to cut work flow which requires lamination. The problem is a weeding part. Even the shapes are cut out but they still partially hang to the vinyl to be removed and therefore when I lift the vinyl to be removed it lifts parts that...

Wouldn't be better to post your question in a separate thread?

Great suggestions. Even myself I was asking myself whether dumpers could be the source of problem. I agree that this is some kind of ink starvation issue. I can see it when the waves are layered over each other. On that note, would anybody recommend me a supplier who has genuine dumpers for my...

CMYK 100,100,100,100 it is great idea. I will certainly try it as a workaround.

I usually print wave and fine, but I tried couple different setting with no success.

I have been trying to print decals with solid black background, but I couldn't get rid of banding on black. I attached an image of print. It looks awful. I have done tons of cleaning and head soaking, with intention restoring those two missing nozzles, but I couldn't restore them. I am not sure...

Thank you everybody for your input. It is very helpful. Cheers, Robson

Hi everybody, I am planning to offer banners to my clients and in this regard would help me If I knew what the most wanted types of banners are so I can stock up right material. Please can you tell me from your personal experience what would be 2 most sought after banner types from the list...

I have set it to 3 hours. I have no problem to run cleaning manually.

Hi everybody, I have issue with the printer, that the ink dries on the head and causes clogging. I did couple of tests, when I realized that auto cleaning function is set but it is not doing any cleaning which results in the problems I have been experiencing. I bought this printer second hand...