Recent content by RoyalCask

Hi all! So as anyone who has seen my posts knows, I am obviously new to all of this. Catching on fast but having one final issue - I'm cutting using a mat so I can fully cut through my contour cuts...however, having it at full force cuts still don't cleanly separate from the sheet. Even...

This is the issue I'm having (doing test cuts, so ignore the graphics) - this time it started scanning down the page, where the other times it started to the far right of the plotter.

Hi all! I'm doing a contour cut on my CE6000 and am having an issue - regardless of where I set the origin (or when Cutting Master promos to align the sensor over the first mark) the machine pulls the head all the way to the right and tries scanning to the very right...which of course fails as...

FC8000 Not Cutting Top Inch - Contour Cutting Is there a margin setting or something that restricts cutting within an inch or so of the organ point? If so, can I turn it off? Thanks all!

Hi Bob, I'm completely new to this. Where exactly do I set that?

Hey everyone, I have a Vinyl Express which is a rebranded FC8000 and am trying to figure out which software I can use (preferably not Flexi as it's super expensive) to do bombsight registration? I design in Illustrator, so I don't need a design software, just something that lets me do contour...

I know this is old - what software do you use when doing bombsight registration with an FC8000?