• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Recent content by w2csa

  1. Can you use transfer tape in a laser?

    Transfer tapes fine especially for acrylic

  2. Overcoming hurdles

    Youtube and this forum are excellent recourses. Also Facebook groups can be very helpful especially those specific to your equipment and software.

  3. Stock vector

    I use shutterstock as well
  4.

    Sublimation mugs - stale??

    Could be that ‘‘tis set of mugs were not properly coated with polymer.

  5. All of a sudden it says now heating. I have to hit pause to start printing.

    I had the same problem, I finally had to replace the heater power board
  6.

    Brass Plaque source?

    That looks like either Rowmark satin gold/black acrylic or dye sun gold aluminum. As for the holders Johnson plastics or JDS industries would be possible suppliers.

  7. Hi, Newb with a software question

    I’ve been using Corel for 15 years. I also have the adobe suite. All are good. Welcome to the forum.

  8. Sublimation Printers

    I like the Sawgrass printers

  9. Engraving 2 color plastic name tags

    Laser will be a lot cleaner

  10. Outta curiosity................................................................................

    I use them for the bronze plaques, very satisfied. I have gotten a few emails lately,

  11. sp300 heater power board replacement

    Mission accomplished, thanks for your help!

  12. sp300 heater power board replacement

    Thanks! I'm going in....

  13. sp300 heater power board replacement

    The front dryer heater is not heating past about 98 degrees. My service guy swapped with the print dryer and the problem followed. He was going to change out the board but did not have one. He then advised that he cant get them from Roland anymore. I found one on Ebay. I had removed the lower...

  14. sp300 heater power board replacement

    Would this be the front lower panel? Thanks

  15. sp300 heater power board replacement

    Thanks Terry, Unfortunately that's the heater control board, its the heater power board located in the bottom of the printer. Thanks for your response.
See more
Top