Search results

Melt and reglue is because of heat. Heat is because you are not removing the heat and chips quickly enough - ie X Y speed is too slow. (or conversely cutter RPM is too fast, for the travel speed you are using)

Well done. Save it preciously!

I have two suggestions: try and label a blank CD or a backup copy CD as FCCDv76_FCAIIv76 (which translates as the initials of Fine Cut Corel Draw version 7.6 & Fine Cut Adobe Illustrator same version, but I can;t say why there are two Is or is it an eye and an el ?) Try serial issuance...

No idea... how do you lose something as important as that? The original cd wasn't actually labelled Finecut, but something convoluted and doubled like FCv7_FCu_2 or something like that. What surprised me was it IS broken on the inner hole, but after a year of sitting not plugged into the CD...

Kipling's "If" has always been a wonderful poem... (but I've never heard of it referred to for tennis...?)

I know only what I was told... and it seems like yes, they didn't check the sensor - but it's hard to get to. I had to wet a handkerchied with isopropyl alcohol, and pass it underneath back and forth a few times, and that did the trick. The sensor was not where I thought it was. Only after I...

It would be... but my story is we bought it cheaply as the previous owner could not get the crop mark detection to work. Mimaki techs came out, replaced a lot of it and it still failed. They then got a print-and-cut machine, and did not need this or their old JV33. As a plotter, used with...

I have one- but never perf cut with it- just ordinary plotting. Lovely machine. Of course you need Finecut software with it or it won't work - make sure you get that.

That made ALL the difference!. I'd downloaded an offline installer for the net3.5, and it failed to work. After following the link there about how to get the net 3.5 installer from the Win10 setup iso, via a batch file, it was so quick it was amazing. Then I had to find the original broken FC...

thanks a lot. I appreciate that.

Update, for the record: I downloaded the Finecut 9.3 update, ran it, and it found Corel 2019, installed the FC tools in it, but then it wants the serial number. (Serials are a new feature for Finecut 9.) The offline serial generator works if you have an old Finecut cd, BUT... when I ran it, it...

Built to last... and they do. But you need an older 32-bit PC with an LPT. Drivers are simple- and work straight from Corel Draw - any version since version 7.5.

I've been using out-of-date genuine inks for some years - up to 3, and in some cases close to 4 years out of date, with zero ink problems. The console just gives you a message asking you to 'OK' the use of past date inks, and you click to confirm, and onward it goes. Occasionally it6 will warn...

I can't stand Edge, let alone Win 10. W7 way way better.

Thanks for the news - are you in USA, UK, Europe, or where?

Keep experimenting. The laser vapourises cast acrylic. Extruded, I do not bother with except for non-laser use, where I need a floppier product. Too much heat is asking for trouble. Too much power is the same. You need just enough to go through with not much extra. The air assist will help put...

You need to figure out if they ARE being deliberately cheap, and if they seriously expect a Mercedes paint job for the cost of a Volkswagon?

Just use the original Signblazer CD that your boss still has. You only said the computer broke, not the CDs as well... Signblazer was once considered pretty cutting-edge technology!

I'd love to say yes, but at the moment can't even find half that much...

why not 2-pack urethane paint, instead of powdercoat?