Search results

A two point landing is easy, but a three point landing is almost always gonna not be entirely level, especially if people not used to doing it will be doing it. Also, why not put spring clips in it as I don't think it will be too easy with grommets holding up the banner and not the pipe per...

Yeah, those are nice, but when looking at some of the pictures, it appears that once ya get over a certain length, you'll need some sort of center support. Will this 4' x 12' banner be hung from the ceiling or a wall where center supports would help ??

For that length, look into black water pipe. It comes in all kindsa lengths and shouldn't sag at that short length. Usually, we'll put a grommet at the ends and wire tie it shut.... just like a regular pole banner. You could use regular decorative chain stuck inside the bottom pocket just for...

That's an easy one. No one said you need to agree with me. Unless you ARE an online supplier, don't compete with online companies. Any of our cor-X products are wiped down in the process I described above. However, our customers are paying for the service we provide. We don't do...

Question is..... if this is for flatbed printing, why worry about it. Sure, you want a good product, but if they don't wanna use a good substrate, why should you knock yourself out to make a piece of sh!t beautiful ?? It's all relative. I just made arrangements with a guy this afternoon to...

Back in the late 70's I took on a side gig to supplement my income and rain-X was a huge seller. Only one thing, it would wear off after about 3 or 4 months. We talked to the manufactures and back then there really wasn't anything that could remove it completely. About the only thing is lotsa...

If you're talking about 4x8's, you must move along in sections. You spray it on, wipe it clean and keep wiping that area until it's thoroughly dry. Then, move to the next area and repeat. One person can do a full sheet in four passes. Do not let the alcohol air dry. That does nothing...

Hahahaaa.... well, I'm glad that's all cleared up........ Now, back to finding that rascal.

Well, somebody left the 'i' out and I just wondered at that point. Good luck with that piece of beauteous work. :wink:

I have no idea of the type face, but what in the world does that spell ??

Just did a sheriff's suv with the exact same flag. All was reflective, but the words and stuff were all separate reflective pieces. That mockup the word is very crooked.

HAhahahaaaa.......... Just dawned on me. This OP gives grief to someone for not keeping him informed and thanking him for a legit request. However, the OP puts up a fake request for no particular reason, other than to waste people's time and gives them all grief when trying to help him...

Just about every recommendation here is a sound one..... for someone with experience and knows what they're doing. My suggestions were based upon the knowledge the OP set forth. Simply making a face with the rounded ends and not making any trips to the location sounds foolish. If you are as...

I was just talking about this very type of scenario over the weekend with someone. Has nothing to do with someone being nice or mean, just cheap or willing to pony up and do it right. Emotions cannot be a part of the equation. Things either are or they are not. The time it takes for you to...

Personally, I totally dislike fixing someone else's problems, especially when they wanna get out of it cheaply. I'd tell them they need to start over with a new cabinet, face and innards. Otherwise, it's never gonna end. Tht's why it fell apart this time. The customer is most likely a cheap...

Do you think it was new or a retrofit, that went bad ??

Nope, just a "polished" turd.

I always empty mine before I leave home......................

Nope. Replaced it with joe namath. Come the new year and I think we'll put up............ and this was long before cheech & chong................

We have totally different printers, but I've seen that same look and usually it was we had the head set too high or too much static in the place.