-
I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...
Search results
-
Graphics Designer/Signpainter
Welcome from OK- The Big Squeegee
- Post #3
- Forum: New Member Introductions
-
-
Check out my mobile sign van.
Welcome from OK. Very nice setup!- The Big Squeegee
- Post #18
- Forum: New Member Introductions
-
Hello From Dublin Ireland
Welcome from OK USA. Things are picking up for us here.- The Big Squeegee
- Post #15
- Forum: New Member Introductions
-
-
Just a guy from Brazil.
Welcome from OK USA- The Big Squeegee
- Post #15
- Forum: New Member Introductions
-
Cutting an open end circle in 7.6v2
I never had a program that would close off the ends of an open letter. You can either make a cut with a knife or put pressure on the point as you're weeding and tear it off. It is always nice to have some registration marks to line the 2 pieces up with. I'm not familiar with that program but...- The Big Squeegee
- Post #2
- Forum: Flexi
-
-
-
-
-
-
-
Printing on magnetics with my Versacamm
Magnetic materials are clay based and will dull whatever knife you use rather quickly.- The Big Squeegee
- Post #13
- Forum: Roland
-
-
-
-
Quick Printer turned sign guy.
Welcome from OK. The solution is less complicated than you might think.- The Big Squeegee
- Post #19
- Forum: New Member Introductions
-
-
-
asking for help on a mutoh falcon 48 inch
The most probable cause is that the ink is not filling the head up. You should check each section of the system separately to see where the problem is. Let's assume the head is working fine. The next section in line is the cleaning station. Remove the head from the cleaning station and check...- The Big Squeegee
- Post #10
- Forum: Mutoh