Search results

you are very lucky that Smoke Jaguar gave you some tips on what to do, I had the same problem, but no ink was coming when purged, yellow and cyan, on printed test, only half of the yellow and cyan was printing, did as much as I could and not luck, had to replace print head, (about ($6500 with...

I will add a piece of plywood 12" by the length of your table, with hinges to be folded down when not needed, just make sure that you do not cut on the extended side, sand the plywood to a smooth finish, you may not spend more than $200..... that is what I am doing, my table is 48" x 120".

I will vote for you, as long is not dem.

check the chips in the cartridges, sometimes, I sand the chip and will be ok.

when you say, less than 1500 ml used, is that 1499ml?, I was told by a tech that the print heads should be replaced when they reach 1200ml......

I also still have the CD, could get the files and send it by wetrasfer.

I did it one time, when I forgot to print the crop marks on a job, I had to set it up sacrificing one row of images in order to add the crop marks. what I did is to print a small rectangle, about 12x20 on that roland and add the crop marks, then I cut some black circles using black vinyl, cut...

change the black to a rich black.

.....for occasional use? I rather send my prints to a vendor.....

I still have a Roland, RE640, and printing great, but that issue, I found out that is the feed calibration, if the print is short, increase the feed calibration for about .5%, try it and increase it as needed, I have done up to .15% if the calibration is too much, you will create banding) when...

to prevent something like this, I usually place all the images within the size I want to print in Illustrator, that way, I will have one file and one cutline, (even I have several images in it) but it works much better, I do not have "onyx thrive" the one for nesting, I just use the "conserve...

if is not gloss finish, I will sand the acrylic, that is the best to get a great ink adhesion.

to my opinion, as it happened to me before and learned from it, you may be stretching the vinyl when is being laminating, that more likely is the problem.

to my opinion, as it happened to me before and learned from it, you may be stretching the vinyl when is being laminating, that more likely is the problem.

to my opinion, as it happened to me before and learned from it, you may be stretching the vinyl when is being laminating, that more likely is the problem.

Me too, I have been using this material for about year and a half, last friday, I just installed a 118' tall by 34fett in length of this material and the thickness helps a lot for install, using a latex printer, no worry about scratches. GF came out with a demanded 227, but is about 3.2mil. I...

remove and reinstall, do no do updates.

..... and on top of what the guys above said, sometimes, that or those fibers are not next to the print head, but away from it, it happened to me when I did some cleanings and no way to get rid of them, until I cleaned around the print head, and on the rest of the print head case, I mean the...

How to you trim the vinyl without cutting the foam board? As I understand, you want to cut the vinyl but not the foamboard, is this is correct, cut the vinyl first and then mount on foamboard. now if you want to cut the mounted graphic, then use a good ruler and a sharp blade, I am able to cut...

Thanks, I was looking into that material also, ..... my boss when ahead and suggested the customer to clean the drums and the job was cancelled for the moment.