Search results

He said he is getting into the HOBBY.. He said he wants to DABBLE. Looks to me like its a tourist walking through

It appears that you are not a signmaker in the business. It appears that you will be making your own personal decals for your hobby. And it appears that you will be trying to get work for your daughters team just as a hobbyist. Cutting you own decals is fine, In fact there are other hobby sites...

can you hand paint signs? Do you have a sign shop? What other sign software do you have?

The wear strip will be $25 bux at anagraph. Yes you can turn it over if the wear is not thru the strip into the other side. I just replaced a wear strip on a machine where the user let it cut to both sides. I finally got him to let me have that cutter since he abused it too much from not...

pivot profile praise prompt./

trimmed edges of laminated stuff almost always peels Trimmed edges of unlaminated stuff almost always peels. Vinyl trimmed up to the edge of the substrate using the substrate as a a guide will peel, curl back or however you wish to term it..

I would not give the skin of a gnats butt for this information. We all know stucco is a particulate product. Just like sheet rock concrete etc. These particles are bonded to each other via some chemical reaction along with some kind fo bonding agent. All of us also know that divots of this...

This type of marketing does not work all that well. Not to worry. This bizz model is proven not be the most effective. He may be getting work yes,, But not in the volum he could if the wording was different.

I use textures in my print ads a lot. But I dim them down to about 20% so they are just a ghost. In fact I am doing just that right now with a print ad that will be inserts in a newspaper. I think it would be nice to get a custom texture made. There are few that meet the needs of some specialty...

get the nortons remover off their site and remove all of nortons virus.

You will hate it for sure. The node points are nearly impossible to grasp if you can even see them. It will be revenge of the evasive nodes.

he is a friggin idiot. It's persons like you that are making hard working real technicians look like morons. Go back to your burger king job and make those biscuits. Better yet, go back to the junk yard job. You are better qualified for that. Geeses. I can't take it any more.

you are entering the wrong segment of this business. There are already very large companies doing whole sale yard signs and magnetic for less than a couple of dollars each. Their economies of scale are ridiculously low. So you don't have a chance in hell. You are about 5 years too late for ding...

yes, that is the problem the temps have to be right

I had a 36" printer.. Right away I found I needed a bigger one. I got a 60" printer and ran many hundreds of feet of 54 inch material and rarely ran 60" material. About 20% was under 36 inches. If I were to get another printer again. I would definably get at least a 54 inch machine.

very important information

Rapid remover has proved itself to be about the best..

i have never heard of a SATA failure like this. They either work or not. Check the drivers.

this is not tint. Water will not loosen it.

yes, adding a layer of vinyl over that old stuff has worked for me in the past. Try it..