• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. body emblem holes

    yeah went the plugs for my recent install, was ok. not sure i'll use it often?
  3.

    question areas

    One more concern is when trimming doors, I notice sometimes the cut is not straight, seems due to relaxed vinyl?

  4. wraps alone

    Like to see these extrusions..post a pic when you can

  5. wraps alone

    Try just rolling the sheet up,from the bottom yeah did that for years, but tends to bend at each end, especially in 100 degrees

  6. wraps alone

    Jason, so yu peel all the backing off each panel? I used a pvc pipe today to roll the vinyl up on as I applied top to bottom..worked pretty well keeping the roll straight instead of bending on each side.
  7.

    question areas

    I agree with not wrapping...I'm gonna just trim a straight line out to the rear following the door lines..?
  8.

    helmet

    Yeah..are those fingers I see on the edges though?

  9. ij180v3 bubbles

    I noticed a couple of small bubbles in ij180v3, they wouldnt push out as in Oracal products...had to pinhole? Any one else have this happen?

  10. wraps alone

    Just wondering what techniques, tips are being used for guys wrapping with no help? I like the magnets for positioning, than tape,etc...

  11. Hood Wrap in Gainesville, FL

    Pm sent

  12. missing fonts

    When I open a file created in flexi, it says the font doesnt exist and wants to replace. I had to type a report in Spanish for a customer and not surewhat may have happened when I changed the language.?? Thanks
  13.

    helmet

    What method, steps would you take on wrapping this helmet? I have seen the three piece work on most helmets, but not sure on this one...
  14.

    question areas

    yeah me either just thinking you might see that color in contrast to the green that's going on it...underneath
  15.

    question areas

    nobody?
  16.

    question areas

    bump
  17.

    Finished our first wrap

    Yeah, I've just seen too many installs here where the deep recession fender wells were done wrong and fail, just wondering..
  18.

    question areas

    Customer doesn't want to wrap roof...it's jacked about 8', butstill see some of roof, think of just going up on roof a few inches? Also no running boards going back on..what to do on the very bottom? I am thinking paint..otherwisw wrap with holes evrywhere?? sorry for the bad pics..phone..thanks
  19.

    Finished our first wrap

    Looks readable..not too crazy. What media, how were the fender wells installed?

  20. wrap panels

    ya be surprised what I see here....a panel seam in the middle of a door 30" wide..

  21. wrap panels

    Yeah?..I like it, just give a few inches bleed on each side...good to go...
Top