Search results

There is a glass encoder disc inside the motor that needs cleaning. You need to remove the side panel to be able to remove the motor. Once you have it out, you need to unsolder the PCB to be able to clean the disk. Resolder and replace and you are good to go again.

Latest version for SP-540V is 5.51 Don't use transparencies together with cutpaths. To test, create a path with a spot color CutContour and save it as a EPS.

Firmware is the same for all sizes The DIP switch need to be set correctly on the board.

Sounds like electric defect of the head.

Erratic movements come from your data/driving software.(given the unit works as it should) Tracking needs to be analyzed. (Marks on the vinyl backing need to be clean, not "chewed") I had some units, where I needed to replace the drive drum. This has to be done during warranty by a certified...

Definitely the head. The black ink does that to the head after a couple of years.(EcoMax Black)

Pay for the part, but not the labour and travel. That should be ok for both parties.

Probably not a problem on a Cyber Truck, if someone is brave enough to drive one

You can use SG and SG2 profiles as well... When using SG, make sure they are for TR2 ink.

Sounds like another week in Barcelona...(for training)

If you are thinking about buying a used L365, it's important to know the percentage of the SMK1 and SMK3 counters. That tells about how heavy the machine was used.

Do the limit initialize

Typical beginners fault. Happened to me as well, but should be recognized already, while moving the carriage by hand while oiling the rods. You as a customer are not resonsible for the extra trip, work and material needed. I would never charge for my own fault. Especially when they are so...

Does your Rep know, that he needs to do a manual M-Gap adjustment in service mode, before the automatic M-Gap in user mode really works? While at it, I'd also check the head slant(called bias on Rolands), vertical and horizontal adjustments. These are mandantory at installation... If not done...

If you create the marks in Finecut, you better send the job to the cutter from Finecut as well and not from Flexi.

You can also try to remove all the cartridges and the waste cartridge. (Just pull it out by 50mm/2", no need to remove completely...) Then restart the PC with the utility.

Peck doesn't work with BN20. There is another tool for these beasts called " Service Tool App".

No matter, how small the input file is, the output file gets large, depending on the output size, resolution, dot sizes and so on. The RTL format knows compression, but it's lossless and not as high as in jpeg, so the compression factor depends on the image printed.

VW 6 stopped working on Win7 at around version 6.14. Maybe it was just on 32bit versions, but I'd check first. VS doesn't work on VW6, VSi does.

Have you tried printing with a lower resolution? There was an issue with a Mimaki way way back... maybe still is...