Search results

Just occurred this evening, cyan or lt cyan drip on test print same spot each test. The light cyan dropout has been there for a while and think it might be the cyan head. Anyone see this before with the test print little pool of blue being dragged? Captops are in good shape and just changed the...

Hi- Can anyone who owns these tell me if there is a ton of ink waste with the VG2 or VG3? Approx how many ml's of ink each month in your waste containers? Do these newer models clean each print or only when you tell it to clean? My VG is a nightmare with ink waste and was thinking of getting a...

Is this a normal amount of ink in a week's time with very little usage?? Every other time loading material goes through a clean cycle. Driving me nuts with the waste!! And then a slight clean for test print. (I want to see what the test print shows before a slight clean.) Vg640, TR2 ink...

Every morning the test print looks like the attached and after 1 reg clean comes back perfect and prints like a champ. Replaced all captops and had the tech install and made sure it's seating correctly. Fairly new heads. It also used to jump from one channel to the next. Now its only on the...

I have the latest firmware updates and TR2 ink conversion (Periodic cleaning set to none.) Has anyone figured out how to get around it cleaning before EACH print. I truly believe it is overkill. Watching daily my wasted ink container rise. Sooo much ink waste! Any Roland techs know a way?

This test print is from the service mode more detailed. As you can see there are waves in the Cyan causing slight blurring in actual prints. Fix? or head replacement. Fairly newer head about 9 months no strikes.Regular test print looks good.. any help?

Excellent condition, extremely low hours of use. Comes from 1 man shop, Has been serviced by Roland techs from Pacific Coast Sign Supply since day 1. I can get the report from the tech on usage. Never had a problem. Comes with take up reel. $9995 Located in Portland Oregon. Thanks Joe...

After a couple of cleanings and manual cleanings. How much trouble am I in?? When there's deflection like in the Black and Cyan test print is it curable or do you have to replace? Also the wavy portion on the magenta just started happening. Thanks for any help!

I wonder if it is possible to pause and perform a clean in the middle of a print on a VP540 with Versaworks? It would be helpful on a very long banner that starts to band because of a hair or ??. if anyone knows a solution it would be appreciated!

Is there any other way of aligning banner material on th VP540 other than pulling it from the center and hope for the best? I'm doing 75 ft rolls at a time and re-setting about every 20ft or so...any advice appreciated!

The banding started in a print on a banner so I performe a cleaning.The test print showed magenta drop-out so I did an inspection. In standby the magenta head is dripping ink. Turned the power off and cleaned and seemed to stop but started again halfway through the print. Anybody have a cure or...

My new VP540 keeps going into cleaning mode while printing. It has never done that in the past. Any suggestions? Thanks!

I just upgraded from the Sp540 to the Vp540 and was wondering if anyone has experienced the cleaning function occuring while printing with the VP? This happens every so often while printing in standard and billboard modes. Thanks!