Search results

Has anyone had any luck getting these to play nice with each other, since Onyx has discontinued support for the non-Ultra versions of the JV4? If so, what did you do and where did you get the drivers?

Looking for a reputable supplier for the US. I'm looking for at or under $225 each for the Xaar 126/35 print heads. These will go into an Infiniti Fina 320. Also looking for PHdata cables for the same unit (ribbon cables that go to the print heads from the main controller board). And...

Hello, I was wondering if anyone knows where I can get solvent based dye-sublimation ink for an HP Scitex XL1500 DS. We use one of these units exclusively for 8-color dye-sublimation via a paper transfer method. However, we are unhappy with the potential gammut from the stock HP...

Hello, My boss has just purchased a used HP/Scitex XL1500 and it is expected to be delivered in about a week. He's given me the task of sourcing supplies and such for it. Can anyone point me in the right direction, in the Seattle area, for a technician to set it up for us and train myself...

We are looking into replacing a JV3-250SP that has been having major yellow over-spray issues. Literally, nearly every part in the machine has been replaced. The sad part is that it worked like a champ for over a year, then started to slowly eat itself a month or two after its anniversary. As...

This unit had been working absolutely fine up until Friday. I'm not about to go replacing the y-axis motor, y origin sensor, IO PCB or main PCB on this unit. I'm in way too tight of a time crunch. Does anybody know how I can get at the y origin sensor so I can clean it without muching up the...

What did I do to deserve this? Control circuit board is defective? Is it the main PCB or could it be cause by the slider pcb? This is the same machine that has been acting up for the better part of a month, progressively getting worse. And it gets better - we *NEED* this machine...

I found a website with really inexpensive dampers and wanted to know how they compare. They look slightly different (larger screen filter) and wanted to know what the benefit/difference would really be. Has anyone here used lavainks.com tall dampers with a JV3 and water based inks (we use...

Hi, In my ongoing effort to let our JV3-250SP drive me insane, we are having yet even more issues. At first it was just the yellow head, giving off a bit of a yellow halo around everything with Y in the CMYK mix. Then the behavior spread to other heads, most notably Cyan at the moment...

We've had some issues with this thing for a little bit. It prints "OK" most of the time, but it's been suggested we replace the main board for a couple of very specific reasons. I won't waste time as to why, as that is not the aim of this post. I've replaced print heads and a slider board -...

Hi, We have a JV3 250SP that has been acting up lately. The heads and pump are fine, with no perceptible drop-out noticeable. In short, print quality is good, with a couple very specific exceptions. First issue: Over-all print alignment/registration settings will, on occasion, go completely...

Hey everybody! This is Dan at Warp Exhibits in Seattle. We run two Mimaki JV4 (160 & 180), a JV3 250SP with water-based j-eco inks on paper for heat transfer dye-sub. We also run an Infinito Fina 320 - with solvent ink for heat transfer dye-sub. I have more than 10 year experience working...