I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
At 73 I have my fair share of gray hair so know a little bit about risk management. If they would only make these things a little more affordable to repair. $175 an hour is just not going to happen. Looking for new sensors and those I can install myself.
Go to my post just above yours about the same fan noise. The link has been added for a firmware update that shuts the fan off when the unit is asleep.
Dan Berg
That doesn't even closely match the version I just downloaded. It had a date of June. 2023.
Just went to the website and checked. The only firmware available for the s80600 is the SA11B.
Are you possibly outside the USA?
The word on the street was the new firmware SAO11B 1.16,9000 Firmware was supposed to silence the loud cooling fan, but is hasn't. Any one have this fan issue that the firmware has silenced it?
Known issue for ages. The new firmware is supposed to have fixed it but it has not worked and is still loud as ever. In sleep mode it is supposed to turn off but it doesn't.
Yes I ran my solvent covered swab over it and of course the solvent loosened the adhesive enough for it to fall off. I stuck it back on and it has stayed tight for about two weeks but I will either get another one or make one myself.
I stuck it back on with the adhesive that is on the edges. Pretty sure I know what happened and it was my fault. When I did the manual clean I may have brushed near that area and the solvent on the swab loosed/ dissolved the adhesive.
I think I see where it may have come from. Can I just order another and put it back in myself. Should I not use this printer until I replace it? Just curious what the purpose is?
Quote for 2 electric eyes was $1,000 and $800 to just come out plus repair time. Cannot afford $2500 right now. Need to find someone to help with the jumper wire.
Have a post below about my Seal 62 Base being out of commission due to a bad safety sensor which locks out the laminator from working (It does work in snail mode)
Have a call in to Grimco and awaiting there return call. Would prefer to pay someone on the side that is in se Pa. and could work on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.