Search results

Got my deliveries today, Got matte lam instead of gloss, need asap, not looking forward for a run to the cities in the morning for a job that needs to be done in the am. Actually need about 30 ft but whole roll would suffice.

And pay a employee to run it.

Does anyone have the Maintenance Manual for a 1324?

Awesome, That worked. But there is one more problem now. Seems that the media eye is not registering. Says media end. Normally when load media the rear eye registers media is being loaded and turns on fans, but not now. Uggggg

Had a employee power up the 1324 and had his hand leaning on the panel, started in maintenance mode. Must of reset something before he shut it down, Now its asking for a ink charge. Looks like he reset the print count in there upon looking. I have no cleaning carts on hand is there any way to...

I use a 45 for everything. I use a super stiff squeegee and put all my effort into it, like almost stand on the thing and peel immediately after.

Have you tried a different blade? I found new cc blades and this do not mix well. Do not know if they are to sharp or what but it seems better when I use a used one or a generic. Are you using gloss or matte? I did have more problems with the gloss so I do not purchase it anymore. If the need...

I am cutting some tomorrow, I will post a simple vid or pic of how I am doing it and how I am pulling it. it does take a knack to get used to but I love the stuff.

You will not ruin it from the holder rubbing. If your scoring the plastic liner you will have a bad time. need less blade. That is the biggest mistake I see people make with the PU film is cutting to deep. Then its all over cause it is almost impossible to be saved.

I use siser pu almost daily. Best thing is make sure your not cutting to deep, that makes it hell to transfer. Use a hard squeegee and press like no tomorrow, flip and either peel in one very swift pull and pray or peel slowly and pay attention that you are pulling at the most extreme angle you...

I purchased dang near a pallet of clear shield at a silent auction 6 months ago. Used it before and loved it, Been using a ton of it lately. I have upwards of 150 gallons on hand. Wonder what the shelf life of it is?

Actually mount 2 sheets together, then cut. haha

Double Sided Mounting Film 2 of them together? I ran into the same problem 2 years ago. I also made 2 sets, but just now thought of the film idea.

I have never seen that problem printing on lam. Is it a anti graffiti lam? about once a month at least I find some use for printing on lam. I just clean it first with a little iso then print away. Only reason I clean is to prevent fish eyes and to delint.

Same thing here. "My cell is not for business. Call the shop number please". I say that when they do call. Some do not call back but mostly they are tire kickers.

I use this also

Anyone out there know where to purchase this image? Cot a request for a small project with this truck and trailer. Can find the picture everywhere but no where can I find where to purchase any decent size of it.

I have fulfilled three so far from the parent site. I do not watch it close enough. Getting better though

Deeper is my advice. How big of "u" channel?

So these are not your first 2 pieces and you did not just start this? You have the process down now, been selling a lot of them and wondering if you are charging correct? Your first post suggested these were your first 2 and a one off, but now you say you are and have been in full production of...