Search results

got gerber

mdf on top of pvc I have just resurfaced our sabre 408 with pvc but I'd like to preserve it cuz its only less than a 1/4 inch thick and its attached with lords adhesive. I had to mill off the last surface (which) was on for 5 years) I purchased 3/4 inch medex and surfaced both sides and...

Need CNC repair service for a Sabre 408 with alignment issues, I think it needs to be calibrated. Does anyone know of a company that repairs them other than Gerber In the NY or tri state area? Their labor rates are ridiculous. Thoughts?

I have a gerber sabre 408 using Enroute, and the problem is routing mutiple objects with multiple passes. It seems the more objects I have in one job and the broader the space across the table, the alignmnet between the passes gets worse. Is this a communication issue between Enroute and Gerber...

I began routing some dimensional HDU letters, they involve cutting them out and contouring the top edge, rounding it out. Well apparently I should of used the contouring bit first because many of them moved, some did even with bridges holding them. Going to attempt to put the letters not ruined...

Ground wire location One end attaches to the hose at the point where it meets the shroud. Then thru the hose into the vacuum itself then out and attached to the back of the tower where everything is plugged in. I just can't think of a specific spot on the back, whether there is one or not.

I just upgraded to 4.1 in Enroute having trouble drawing. I draw out the shape, hit apply and they disappear. Anybody know what I'm missing here?

Does anybody have any recommendations for a work table surfacer? An industrial polyurethane for example? Something brushable, something that can hold up to cutting. Any input appreciated, thanks.

thanks I have used the 33000 series, and a gerber double fluted bit as well so it has to be down to the speed and direction. Thanks guys I'll give it a go again.

I have a Gerber Sabre 408 was wondering what is the best bit for aluminum composite (Durabond). I have always had trouble with rough edges. Will reversing the cutting direction fix this? Is there a bit specialized for aluminum composite? I"m using 1/8th inch material most of the time. Any help...

I am using enroute4 on a Gerber 408, is it possible to change the cutting direction on a toolpath? A coworker says if I'm getting a rough edge on the piece, changing the cutting direction would help. Where would the option be?

I am trying to figure out in Enroute 4 how to v carve following the contour, not a male or female path. There is a box that I check that follows the contour however the Gerber Sabre 408 we use will not cut it. It just floats above the material whenever I check that box. Anybody know what step...

I use a Gerber sabre 408 and I was wondering if anyone out there knows of a chart that suggests cutting speeds for substrates and their thicknesses. I have been having issues with aluminum and plexiglass literally pulling the bit out of the collet while routing and burying into the table. The...

I recently purchased MDF from the local lumber store to use on a Gerber Sabre 408 as a sacrificial board. When routing aluminum the water coolant spray swells up the MDF and throws off the cutting depth. Is there MDF to use that does not do this?