I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes.
Click to Support Signs101 ...
We have a VS-640 and have perfcut a couple of full MX kits on very thick vinyl & laminate without problems. Just extend your blade at the machine (there are marker 'notches' so you know where you're at) and in the rip settings increase your perf pressure. Do a couple of test cuts to make sure...
Nice little tip this is! Thanks for sharing. The only probelm I have is the gap of wasted media that is left between each sheet. Can anybody tell me if there is a way to reduce that? I have reduced the 'Page Space' option to 0mm but it still forward the media out a few inches inbetween each sheet.
Thanks guys. I live in a barn so the room loses heat pretty quickly. I have a thermostat heater in the printing room to keep it warm but gonna have to crank it up shortly as it's getting cold. My Dad pays the electric bill so i can see an argument brewing!
I have a Roland VS-640 and I want to know about what sort of room temperature conditions people operate in for digital print? It's starting to get cold here and I want to be safe for when winter properly hits. I have an electric thermostat heater keeping the room around 17C/65F. I would risk...
making sure laminate is square
Hey there, just saw this post. Has anybody got any tips to making sure the print is square in the laminator? I've done a few runs and have managed to keep everything in but it was more luck than judgement! I see somebody recommends to tighten the feed roll, does...
Am reviving a bit of an old post here but does anybody else have anything to add to this? I'm torn between the Roland VS 540 and Mimaki CJV-130. Any advice would be appreciated!
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.