• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

Search results

  1. Mutoh RJ900 Wasatch Problem ?

    Update Turns out some parameters in the printer got changed some how, do not know if power surge or what...?? Now printing. Thanks to all who responded.

  3. Mutoh RJ900 Wasatch Problem ?

    Mutoh RJ900C Sublimation. When I load a rip , the printer will only print about 8 to 10 inches of artwork....will not print the whole 42 inch width of file. Will print total length of file but will not print width. ?? I use wasatch Softrip....never had a problem before. I have re-booted and re...

  4. Mutoh RJ900C Paper Initial Problem

    UPDATE : My firmware does not list "mediaint"...if someone can tell me how to turn it off please let me know...I agree , I do not need the media width to be measured every time I want to print...(use same paper everytime) However, was able to correct my overcurrent errors. The "pre-feed" amount...

  5. RJ900C Ink won't Refill

    Late Update: Turns out my dealer sent wrong dampers, they would not seal on Head. Sucking air, not ink. After correct damper install, found out Head was blown out. Repairman never seen anything like it, cause unknown. If anyone in NE Ohio looking for skilled and affordable repair tech, let me...

  6. Mutoh RJ900C Paper Initial Problem

    My menu must be different than yours....no "mediainit" listed. Now, everytime I turn it on...it says undefined paper and cannot get any farther. Must have multiple problems with this thing. Thanks for your time and effort.

  7. Mutoh RJ900C Paper Initial Problem

    I did go to menu and scrolled to media settings...but saw no prompt for turning off "media size" or anything that looked similar. Have read user manual and service manual but no luck.

  8. Mutoh RJ900C Paper Initial Problem

    I have service manual...does not explain how to turn off that function. ?? If you could tell me how, that would be great ! Thanks

  9. Mutoh RJ900C Paper Initial Problem

    Great advice....will try after I figure out how to turn that function off. Thanks

  10. Mutoh RJ900C Paper Initial Problem

    RJ900C Sublimation Printer. Start up...all is fine until Paper Initial..Head goes all the way left and stops in middle...then WOOOSH ! paper is thrown towards back of printer a couple inches...Then Beeps Error (EO65 Err) or (E071Err)......Have had this problem before...If I turn off and on...

  11. RJ900C Ink won't Refill

    Ink lines have some ink, mostly air. Dampers empty. I did pull ink into lines and dampers with syringe couple days ago. Lines do not seem to be clogged. Pull ink from Cap ???? Cap seated properly ???? Pump does run, I see it running..also hear it. Maint. station was replaced ...has new...

  12. RJ900C Ink won't Refill

    RJ900C RIO Sublimation If you can answer my question I would be very grateful, I am trying to stay in business. My printer is less than 4 years old. I print sublimation ink. Works great until now. Contacted GraphicsOne when my prints became very light with weave pattern. They recommended : New...
Top