Search results

I just cut a bunch of circles in Komalu with a 1/8 straight cut bit they came out without having to do anything. I ran the machine at 9000 rpm and 200 inch per min here is the bit I used https://www.lowes.com/pd/Bosch-1-8-in-Solid-Carbide-Straight-Router-Bit/1007649

Do you need a union installer like a lot of other shows

Pretty much any carbide bearing bit will work

I just bought a 2 terra Buffalo NAS had a 1 terra that was getting full. Bought it from Micro center for $120 including tax My old Buffalo was 12 years old

I would also look at a ATC spindle and a bigger table. I never heard anyone say I wish I would have gotten a smaller table. You can cut small stuff on a large table but it is a hassle to cut large stuff on a small table

If you have gecko drives they are pretty hardy. Gecko will repair or replace them you just have to get a RMA number from them and send them in. I had 8 repaired and all it cost me was shipping

I also use super bright leds I have some that have been on since early 2014

Yeah you should be able to hold your hand on a furnace. the decal should be on the outer case and not the stack

Did you upgrade your software I had some trouble with one of the upgrades. Call Shopbot and ask them about it they are very nice to talk to and will support their machines. I had one that I was the 3rd owner and they just had me regester it and they provided support for it as they knew what...

Mine with the 4g board stopped pretty quik maybe not on a dime but it didn't move more than a 64 th of an inch. I now have the Centroid Acorn controller on it and that stops about the same.

Try Lightburn software It does more then RD or laserworks You can download a trial version to see if you like it

They look like 2 brackets welded to a plate with one is upside down

click on the node arrow and see how many there are

I use Trupan Mdf from Arauco for my spoil board haven't had a problem with it

I have done a few with AZEK pvc that is holding up to or summers and winters. AZEK is made for out door use.

I think most of those are just relabled Chinese machines. You are paying for the support

Isn't that streel ell bi sexal

Figure at least $600 for the software to make your cut files reliably

20k is a low price hobby machine now, Yoy may be able to get something from China for that but even the Chinese machines a little higher.

Welcome from Northeast Ohio