Search results

Isn't that streel ell bi sexal

Figure at least $600 for the software to make your cut files reliably

20k is a low price hobby machine now, Yoy may be able to get something from China for that but even the Chinese machines a little higher.

Welcome from Northeast Ohio

If you are doing engraving then the Trotec would be the one to go with. It may be the most expensive but the speed will pay for itself in a long run.

Here you would dig the hole 36 to 40 inches deep and pour in a base of concrete. Then when that is set put your posts in and backfill. Also they will use sona tubes put the posts in them and fill with concrete. I have seen to many posts that were set using concrete that the frost had lifted...

Make sure that it is compliant as some architects don't use the ADA standards when specing out signs

You are right about the wind load. I installed sat dishes back in the 80 and a solid dish had the same wind load as a screen one due to the fact of the turbulance the screen caused

Multicam's are pretty much good equiptment. they last for a long time

You never hear someone say man I wish i didn't get that much vaccumm

Wouldn't the room number stay the same or are you going to have 1,5,3,2and 4 in that order

We have both and our Mig welds look just as good as our TIG welds. Mig is easier to learn and if you get good the welds will be great. We do a lot of aluminum trusses for Trade shows and they have to be pretty strong

Is this what you want https://www.thisiscleveland.com/locations/cleveland-script-sign-edgewater-park

A Trotec at 10 times the price should get you a lot of support. Yes they are better built but to recoup that you would need to do a lot of work. I have 2 of the Chinese lasers and can say that I have had good luck with both.

I trick the software saying I want an inlay cut and input the radius if the bit

I use Vcarve and that works for me.

When I first started in printing I was in prepress and made plates for our Goss community presses and also Goss Urbanite

I did a memorial wall letters for our fire department and just use GE silicone using a card board templet to hold them until the silicone set up had to remove them when they moved the wall to new location and had one heck of a time getting the letters off

I have an older Shopbot and it does everything that comes my way for acrylic I have a laser cutter gives me a better edge even then the 100K Bessie I ran at the shop I worked for. In fact I did cut stuff that for that shop would nod try on the Bessie as it was more cost efficient. I could make...

Not true Obama didn't get mocked as the left fake news would try and keep anything bad out of their newscast