Search results

We have a couple of Roland VS640. And one of them is currently driving me nuts, since I can't figure out what is causing these errors: - It can print fine for several days in a row. Mostly printing on 30" rolls. If we change to 54" - or sometimes also on 30" - the print suddendly starts to get...

Just an update on our SP300 and the heads: I came to the conclusion, after 3 attempts to flush the head with cleaning fluid, that it might be better (and cheaper comparing time with money) to replace the head. But then my collegue came up with an idea: Why not swith the heads around, so that...

Here is little tip that we use at our facility: When doing small vinyl letters and numbers (smaller than approx. 8 mm. in height), first cut the letters with a sharp knife with high angle (09U on Graphtec cutters are fine) at a low speed (a speed between 5 or 10). Be very carefull setting the...

It sounds like you need to have an arsenal of asprin and Cola ready :-(. I would not recommend anybody to throw themselves into such a project without having a good background experience - and at least some experiance with the printer, hardware and software. BUT, now that you got the project...

Thanks for the advice. But I have allready tried that :-(. If I look at the test-print it looks more like that half of the black nozzles are firering at a different angle than the rest. Some of the black lines in the test-print are close to each other, than the rest of then the has equal...

Our small SP300v has started having some problems with the black/cyan head. It's only the black part of the head that has problems. It is an annoying problem when we are printing on glossy material such as vinyl, where solid black areas ends up having visible lines of black. It's looks like...

Or - if you live en Denmark as I do - it will get very hot if you don't set it at 240 V :tongue:. (we run at 240 V here in DK - so setting the heaters to 110 V is not a good idea....) /Jesper

I'm sorry for this dual-posting, but I really need som quick responses to this. I have asked the same question on UKsignboards, since there are very few here in Denmark that runs with a setup like our where we use multiple Roland machines via VersaWorks. And the ones that do use Roland, would...