fuse

Hey guys! So recently I was doing some maintenance on my VP300I as one of the manifolds for the head were broken on the damper for yellow. Like a idiot, I disconnected the ribbon cables to the head while the machine was still "On" it was in sleep but it went right over my head to properly turn...

Hi there, I'm new to the forum, but I've come across it a lot through my troubleshooting ventures, so I'm hoping the lovely folks here in the Sign101 community can help me. I have some basic electrical experience and soldering skills, but I'm not 100% confident where to look next with this...

Got a print head that won't print on a mimaki JV3-130 sp2. The head is fine, we can pull ink through, it just won't print at all. Was mentioned to us that it might be a blown micro fuse on the main board. Does anybody know where these are at on the board so we can check them?

Having some issues getting this printer up and running. Roland Soljet Pro 2 SC-540 We bought it without the heads. It had been sitting, without heads for about a year before we purchased it. We replaced the heads, caps, dampers, all 3 pumps and lines from caps to pumps. I was able to draw ink...

Hallo, i'm writing from Italy and i hope you can help me. i'm looking for capacitors near f1 f2 fuses in sp540v main board, where can i buy it? main board blowing fuse always and cables are ok. I replaced black cyan head with no problems and it's printing well. thank you... P.S: sorry for my...

Issue started when running a normal cleaning cycle. The 2 black print heads dropped out. I checked the fuses, and F4 was blown. I replaced the fuse and it blew again. I checked and replaced all cables relating to group A. I swapped the print heads and got a little bit of each black to come...

Hello folks, I have a VersaCamm SP300V that has had some main board problems (that started because of spilling ink on the CK head). The CK head would print nothing. I had a friend put in a new f3 fuse (because it would blow when sub power was turned on). Now I just had him install a c4131...

Hey Guys long time reader of this forum and first time poster. Usually I'm able to find just what I'm looking for on this forum for any question i have but this one has me stumped. My Roland has treated us very well for the past nine years but i think its age is beginning to show... Five...

Hello All, I am a newbie to this forum, so hopefully someone can help me... I am willing to take photos etc, if this helps... Cut a long story short, I powered up my machine, and during bootup, just after initialization (like 5 seconds after pressing power button) I get a beep... and on screen...