• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

graphtec 7000

  1. Graphtec FC7000 vs FC8600

    I currently have a 40" Roland but have been desperately needing a bigger plotter for a while now. With that being said a 54" graphtec FC-7000 MK2-130 just appeared for sale in my area and i'm thinking about pulling the trigger. New to them so was wondering if there are any major differences in...
  2. registering to back at start up

    I have a graphtect fC7000-75 that is a workhorse! I have had this problem twice and can't remember how to fix it. When I start up the machine and select roll1 to get the machine registered to the front right to start cutting it goes to the back of my roll and stops on the left side. I feel like...
  3. Help with settings for Graphtec FC7000 -130... Please

    Does anyone have a 7000 series cutter running with Wasatch and willing to help me check some settings? I've been posting a couple issues lately but I still need just a little help. I replaced the Y motor and the plotter will cut fine in GPGL mode using Cutting Master 2 and CorelX6 (vinyl only)...
  4. Graphtec 7000-130 help please

    I thought I had my Y position error fixed, after cleaning rails etc. it worked great for a little over a week but long story short I ended up replacing my Y motor. The Y position error is gone and the plotter initializes normally, senses the media length and width just fine and will do the cut...
Top