motherboard

Hello everyone, I recently replaced the motherboard of my Mimaki JV33-130, and while the machine starts up fine, I'm facing two persistent issues: Error with Yellow Cartridge: The LED on the Yellow cartridge is blinking red and fixed green. I've already tried replacing the chip reader and the...

Hello, I was wondering if anyone had any information on were to get the small individual components that are on the main board. I am going to buy a new one but am really interested in if it is at all possible to replace some of the small pieces and have a back up for emergencies. This is mostly...

I have an ARETE notcher CE machine. I need a photo of the four DIP switches for the address dips on the two DM6806 Data Module boards. The motherboard is a PCA 6753 running windows 95. I am getting an address I/O error message when the Arete software is loading. Help me pls. Thank you

Hello everyone! My HP45500 UV printer just died. I had to change the power supply, did that and it powers up now but my screen is black. Tech guy at Grimco says that more than likely my motherboard is fried. (part # CH104-67018). hE SAYS THAT hp DOES NOT SELL THIS ANYMORE. iT IS OBSOLETE!! I am...

Guys, Need some help! I`m trying to install a new motherboard on my mutoh RJ900-x and when i log on MSA i keep getting this mensage. Imgur: The most awesome images on the Internet And when i click on ''ok'' it come as printer unknown with no options to update the main firmware...

Guys, Need some help! I`m trying to install a new motherboard on my mutoh RJ900-x and when i log on MSA i keep getting this mensage. Imgur: The most awesome images on the Internet And when i click on ''ok'' it come as printer unknown with no options to update the main firmware...

After being scammed by MACMEDIA, who stole 4 mainboards from me, i have been forced to buy a new VP 540 mainboard for my printer. We bought a brand new RS 540 board from our local Roland dealer and installed the board with all cables etc. In The service manual it says pres left,up and down key...

We had the misfortune of someone tripping over our USB cable connected to our FC8000 and it bent the tabs in our USB port. When I went to straighten them, one broke off. Called a local dealer and he said the USB is connected to the motherboard and we have to replace the entire motherboard at...

The start to my problems... when I load media, restart the machine or anything in general, the media feeds about 4' of material, then goes back through and out the back of the rollers. When I force the material to be in the correct place, the machine reads "Plot OK", but will not cut, test...