• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

need advice

  1. Another Double-Sided Printing Thread

    Hi Folks, I'm printing some double-sided banners for a client on blockout banner material. I've done quite a few previously but never had much success accurately aligning the 2nd side to the 1st. In this instance the banners are quite small and the print length around 1400mm. Even so, the print...

  2. About JV33 tricking to run without inks

    Hello, i have my JV33 3 years powered off. Of course everything is dried. I flushed the printhead, ink lines everything. Changed cap and cleaned cap station. Changed pump. Basically everything is cleaned. I want to power it on without inks, just to check that everything else works fine.I dont...

  3. JV33 160BS Firmware

    Hi All, Have done a fair bit of searching and haven't quite got to the answer...wondering if anyone know the answer to this. Currently I have an additional machine a JV33 160BS. As far as I can tell from the threads the BS is is different set of firmware? In the bible were someone has...

  4. Need Help Looking to potentially buy a used SSK Designtech60 but want input first!

    Hello, We have an opportunity to purchase a medium use SSK DesignTech 60 cutting plotter. We are being asked for $1200 which would cover the cost of the cutting plotter, the computer, dongle, software, and some material (no monitor included). The unit has been around a while but appears in...
Top