• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

plotting problem

  1.

    Graphtec 8600 Not Accurate

    Our FC8600 has started to become less accurate. It drifts in accuracy after about 2-3 feet. See my photos below. The W is dead on but 2-3 feet down the roll the C has drifted by about 1/8 of an inch. Does anyone know what we can do to solve this? Our grit rollers seem to be clean and...
    • Chicken Quasar
    • Thread
    • accuracy drifting graphtec graphtec 8600 grit rollers help inaccurate plotter plotting plotting problem
    • Replies: 11
    • Forum: Graphtec

  2. Suggestions Graphtec FC9000-160 Large Window Tint Plotting

    Hi everyone, I'm working on a job with large window film pieces. (commercial) Aproximently, 60" x 80". I have no problem with the installation but, when plotting out the cut, the material gets all jammed up (creased) because of the static against the film. I set the speed to 10 (slow) so I...
    • craigwojo
    • Thread
    • large plotting problem window tint
    • Replies: 3
    • Forum: Graphtec

  3. Need Help Mimaki CG-160fx plotting issues.

    Hello, Our shop has been having a lot of inconsistencies with our Mimaki CG-160fx. Some of the issues include, the blade will not lift up all the way and drags through the vinyl, sometimes the plotter doesn't cut the entire file or cuts too deep or too shallow. Also, we have encountered the...
    • Sign Impressions
    • Thread
    • help mimaki 150-160 plotting problem vinyl
    • Replies: 0
    • Forum: Vinyl

  4. Need Help Plotting issue Mimaki cg 130 fx finecut 8 and coreldraw x5

    Ok here's the situation I'm trying to get my CG-130FX to plot but unfortunately I don't have the computer that I use to plot from so I have had to re set up everything and I must be missing something because it won't work and I am unsure why. **Special note on the plotter the USB port is broken...

  5. Roland SC 545 - Colorgate PS7 - Won't cut from spot colors??

    Hi everyone, New to this site looking for a bit of help. I have a Roland SC 545-EX Printer, I'm using Colorgate PS7 Software. It's printing fine and will cut from job frame no problem. What I'm trying to do is get it to cut from spot colors so I can get it to cut to the shape its after...

  6. Wasatch EPS cut path

    Well this is a new issue for me. I usually use PDF files with a cut path in Wasatch (I run Wasatch 6.3) and have no problems. I sent a small print file as an EPS with a cut path, printed it and it never put the file in the cut queue. I sent the same file as a PDF with the exact cut path and in...

  7. Camm-1 Pro GX-300 cutting 2% smaller - PLEASE HELP

    Wondering if anybody out there can help me with this odd issue. I am using Sign Wizard 6.5 with a Camm-1 Pro GX-300 and everything is cutting 2% smaller than what it should be. (i.e. 100mm box ends up cutting 98mm). It could have been happening for quite a while as I have only noticed it when...
Top