• I want to thank all the members that have upgraded your accounts. I truly appreciate your support of the site monetarily. Supporting the site keeps this site up and running as a lot of work daily goes on behind the scenes. Click to Support Signs101 ...

roland vp-540

  1. VP 300i - Potential Dead Fuse?

    Hey guys! So recently I was doing some maintenance on my VP300I as one of the manifolds for the head were broken on the damper for yellow. Like a idiot, I disconnected the ribbon cables to the head while the machine was still "On" it was in sleep but it went right over my head to properly turn...
    • NightShift Vinyl
    • Thread
    • dx4 fuse help maintanence print head roland roland vp-540 transistor vp-300 vp-300i
    • Replies: 7
    • Forum: Roland
  2.

    VP-540 Printhead Streaking Lines

    I purchased a DX2 printhead for my Roland VP-540 less than a month ago and prints streaking horizontal lines across the media for one of the colors (the black printhead). I have attached a picture showing the streaking horizontal lines that happen during printing. I also replaced the head cables...
    • graphicsphere
    • Thread
    • printhead roland vp-540 static electricity streaking lines
    • Replies: 2
    • Forum: Roland

  3. VP-540 Loses Power in VersaWorks when sending job from RIP to Print

    Hi I’m trying to find out if it’s the main board causing a power loss when sending job to printer because it turns on, does cleanings, even prints reports and does test prints to check nozzles but when I send a job from VersaWorks to the printer it just shuts off as soon as it goes from rip to...

  4. HELP Roland VP-540 0110 Linear Encoder Error

    I replaced L-bearings, Scan encoder sensor, strip, and scan motor and it still beeps the same error. I am now suspecting one of the circuit boards primaraly the servo board but at this point I can't just keep spending money. Can someone please help. What I do notice is that when first turning...
    • ced
    • Thread
    • Replies: 2
    • Forum: Roland
  5.

    Roland VP-540 Cyan overspray

    I've run into a problem I haven't encountered before, and not sure what the issue is. The Cyan head seems to be producing a lot of overspray, and the alignment of the Black nozzles seems to be out of whack. I've attached a few photos, any feedback would be helpful. I've had to learn this...

  6. VP-540 not seeing correct media width

    hi All my machine will not detect the correct width of media in use, it always goes to the widest points regardless of whatever width media is loaded can anybody suggest some solution , the edge detector is set to enable. thanks
  7.

    vP-540 Colors printing differently after initial run

    Was wondering if anyone has come across this issue with their Roland VP-540 or other Roland using Versaworks. Here is an example of what is happening: We print one side of a vehicle wrap. The print and the color are great. For whatever reason we need to reprint one of the panels and the...

  8. Roland Color Issue - Panels printing different colors than original

    Was wondering if anyone has come across this issue with their Roland VP-540 or other large format printer. Here is an example of what is happening: We print one side of a vehicle wrap. The print and the color is great! For whatever reason we need to reprint one of the panels and the color...

  9. Help! My Verscamm VP-540 has an error message...

    Carriages are seperated??? Is there any way to fix this???? :banghead::banghead::banghead:
Top