strip

Hi I have spare parts for our 260 - including 22 ink cartridges, 10 or so heads, 2 head cleaning cartridges etc but also a spare belt, encoder strip, and sensor with it. Someone locally is interested in the belt and encoder-I'm wondering if they'd be compatoible with our L360, and worth...

Today my new encoder strip arrived and it is not for an SP-300 but an SP-540 Question can I simply cut it down to the correct size and then make a hole in it with a drill bit or do I need to send it back? Thanks Jim

I need to find a Roland Dealer that stocks an encoder strip for an SP-300 and I have already tried Florida Graphics in Clearwater but they did not have one in stock. I also tried using Roland USA to locate another dealer here in Florida but it appears there are not many dealers left. I do not...

I have cleaned my encoder strip many times but never installed a New encoder strip so I have a number of questions. 1. Does the printer have to be in Service mode first? 2. Is there a spring tension that needs to be set? 3. I do have the Service Manuel for my SP-300 but I did find much...

Hi guys, Does anyone have any suggestions on alternatives for the cutting strip on our FC8000? At over $50cdn each time they're an expensive consumable.. Thanks, Steve

I used 5050SMD Cool White water proof led strip to lighten up 6' x 2' white plastic sign board with cladding sheet back of the board I used 15M (3Rolls) to do this because these cheap led strip not bright enough. i fit this led strip every 2 inch space horizontaly Every thing worked fine for...

I did a rail lubrication like normal and then the carriage moved back and forth to spread the lubricant. When it got to the left side it made a loud noise and gave the 86:01 Substrate Jam warning. There was no substrate in the printer. I did get a spot of oil on the encoder strip while...

Hey All... Came into work today and turned on my printer. It showed all my inks were empty...and they were, my waste tank was full too...that was the 1st thing Replaced all the inks and the printer went through it's start up, did a cleaning. The width came up as 0 and then it says internal...

Pretty sure we need the dampeners, encoder strip and both heads replaced in SP300v . I know prices vary, just trying to find out rough pricing. Techs are less then 10 miles away. Your help is greatly appreciated! Thank you.

Hi everyone. We are replacing some striping on a semi and running into issues with stripping the existing vinyl. It is metallic and very old. Any tips? We have tried heating it up, using RapidRemover, scraping it and at this rate just the hood is going to take at least 3 hours...too long! Any...