Hey all! First time poster....long time lurker. I'm a rookie at the vinyl graphics but getting better. Been out of town for a while... came back last night to laminate some print jobs and about a 2" section of lam had stuck to the bottom roller of my laminator. Hindsight says I should have taken my heat gun and warmed the laminate up before peeling it off the roller, but I didn't. I ended up scarring up the roller terribly. Like can't even laminate any more it's pitted so bad.
I haven't gotten a response yet to see what that roller is worth to replace. Can't imagine it's going to be cheap, sadly. But was wondering if it'd be possible to fill with some sort of epoxy and try to smooth out the roller for inexpensive before I resort to expensive? Any suggestions would be appreciated!!
I haven't gotten a response yet to see what that roller is worth to replace. Can't imagine it's going to be cheap, sadly. But was wondering if it'd be possible to fill with some sort of epoxy and try to smooth out the roller for inexpensive before I resort to expensive? Any suggestions would be appreciated!!
